Free Download Smartcard Authentication Agent and Required Firmware drivers for hp

Important:

Your HP MFP must have the most current firmware BEFORE installing version 2.01 of the Smartcard Authentication Agent PJL.
The "Current Version" date must be "18 Sept 09" or later.

To obtain the correct firmware for the following supported MFPs, follow the links below:

• HP 9250c Digital Sender Firmware
• HP LaserJet CM4730mfp Firmware
• HP LaserJet M3035mfp Firmware
• HP LaserJet M4345mfp Firmware
• HP LaserJet M5035mfp Firmware
• HP LaserJet M9040/9050 MFP Firmware
• HP LaserJet CM6040/6030 MFP Firmware

To obtain the latest version of the Administrator Guide:

• HP MFP Authentication with U.S. DoD Smartcards Administrator Guide

  Use the following order when installing the Smartcard Authentication Agent version 2.01:

  1. Upgrade the firmware to a version with datecode "18 Sept 09" or later.
  2. Install the Smartcard Authentication Agent version 2.01.

  CAUTION: If a 49.4c18 error occurs when the MFP restarts, the cause of the error is installing the Smartcard Authentication Agent version 2.01 update and restarting without the required version of firmware installed.

  To enable the device to boot to Ready after this error message has appeared:

  1. Turn the device off and back on.
  2. Hold down the 9 key during the memory test.
  3. A